-
-
Front bumper
-under the hood take out the caps (inserted upside down) and remove the cover.
-under the pickguard, take out the clips and remove the grille (pull on yourself, hold on the latches).
-under the grills Unscrew the two screws and take out the two clips (twisted and inserted upside down).
-on the perimeter at the bottom of the bumper, Unscrew the screws (spun up) that secure the lower part.
-wrenched the wheel to the left or right side, depending on which side of the bed will be dismantled.
-wheel arches pulled three pistons on each side and removed the fender liner.
-turn down the lockers to the side and Unscrew one screw on each side (spun upwards) holding the bumper to the wings.
-slips a hand inside the wing and Unscrew the nuts that attach the bumper to the wings under the headlights.
-s the assistant pulls gently on the bumper itself.
-remove the connectors from the fog lights (if any).
-if you have headlight washers, disconnect the hose (to fluid from the reservoir flowed to the ground, you must prepare the container or tube)
Rear bumper
-in the trunk, we release the side trim (you need to access the rear part of the rear lights and wings from the inside).
-(in the wagon) behind the panels Unscrew the nuts and remove the tail lights.
-from the trunk, in the wings, Unscrew two screws on each side (twisted upside down).
-(in the wagon) Unscrew one screw on each side under the rear lights.
-on the perimeter in the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up).
-wheel arches free lockers (if any)
-remove the fender liner to the side and Unscrew one screw on each side (spun upwards) holding the corners to the wings.
-with the assistant release the latch in the opening of the trunk and carefully pulls the bumper itself.
-remove the connectors from the sensors (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español