Front bumper
-under the hood take out the caps and Unscrew the screws (twisted and inserted top to bottom) that secure the cover plate over the grille.
-under the pickguard, Unscrew the screws and take out the clips that secure the grille
-released from the latches and remove the grille.
-under the grille, take out the clips that secure the upper part of the bumper.
-on the perimeter in the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up), which secure the protection of the engine and the fender liner to the bumper.
-wrenched the wheel to the left or right side, depending on which side of the bed will be dismantled.
-wheel arches, peel the fender liner.
- move the wing flaps to the side and Unscrew one screw on each side that attach the angles to the wings.
-with the assistant release the latch in the wings (corners pull on yourself) and gently pulls the bumper itself.
-remove the connectors from the fog lights (if any).
-remove connector from the PDC (if any).
-if you have headlight washers, disconnected the hoses.
Rear bumper
-open the trunk lid.
-the trunk release trim panel (if you have open hatches you need to access the rear part of the rear lights).
-Unscrew the nuts is released from the latches and remove the tail lights.
-under the rear lights, Unscrew the screws m and pull out the clips that secure the upper part of the bumper.
-on the perimeter in the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up).
-wheel arches, peel the fender liner.
-remove the fender liner to the side and Unscrew one screw on each side holding the bumper corners to the wings.
-with the assistant release the latch in the wings (pull on yourself), and gently pulls the bumper itself.
-remove connector from the PDC (if any).
How to remove front and rear bumper Nissan Sentra S15 (1998-2005)
How to remove front and rear bumper Nissan Sentra S16 (after 2006)