How to remove front and rear bumper Nissan Almera G15

: Created: 07 September 2019; Last Updated: 02 August 2023

Nissan Almera III G15 (2012-2018)

Front bumper

-open the hood.

-take out the caps (inserted upside down) and remove the cover plate over the grille.

-take out the rivets that secure the upper part of the bumper.

-at the bottom, Unscrew the screws (spun up).

-wrenched the wheel left or right, depending on which side of the bed will disassemble.

-wheel arches vacated lockers and Unscrew one screw on each side (spun upwards) holding the corners to the wings.

-with the assistant release the latch in the wings and bumper pulls gently on yourself.

-remove the connectors from the fog lights (if any).

-remove connector from the PDC (if any).

the attachment of the front bumper Nissan Almera G15

the scheme of fastening of the front bumper Nissan Almera G15

scheme of fastening of the radiator grille of the Nissan Almera G15

Rear bumper

-the trunk release trim panel (need to access the rear part of the rear lights).

-for casings Unscrew two nuts from each side and remove the tail lights.

-the rear lights take out the caps (inserted upside down) and Unscrew one screw on each side in the doorway of the trunk.

-wheel arches, peel the fender liner.

-for wheel arch liners Unscrew one screw on each side (spun upwards) that secure the corner bumper to the wings.

-at the bottom, Unscrew the screws and take out the caps (twisted and inserted from the bottom up) that secure the lower part.

-with the assistant release the latch in the wings, and gently pulls the bumper itself.

-remove the connectors from the equipment (if any).

the attachment of the rear bumper Nissan Almera G15

the scheme of fastening of the rear bumper Nissan Almera G15

scheme of fastening of rear lights Nissan Almera G15