-
-
-
Nissan Murano III Z52 (2014-2023)
Depending on the year of manufacture, the attachment points may vary slightly.
Front bumper
-open the hood.
-under the hood take out fifteen caps (inserted from top to bottom) that secure the trim and grille.
-behind the grille, unscrew the two screws (take out two pistons) that secure the upper part of the front bumper.
-from the bottom, unscrew ten screws (spun up) that secure the bottom.
-turn the wheels to the side.
-in the wheel arches, we unscrew the faults and release the lining of the arches from the latches (front part).
-for the overlays, unscrew the screws that secure the sides of the bumper.
-we release the latch in the wings (pull the corners of the bumper towards you).
-with an assistant, gently pull the bumper forward (look behind the wires).
-disconnect the fog lamp connectors (if any).
Rear bumper
-open the trunk lid.
-from the trunk, unscrew three nuts on each side and remove the rear lights (hold on the latches, pull towards you).
-under the rear lights take out two pistons.
-in the opening of the trunk, unscrew the four screws that secure the upper part of the bumper.
-from the bottom take out six caps (inserted from the bottom up).
-in the wheel arches we take out the caps (unscrew the screws) and release the lining of the arches from the latches (rear part).
-for the lining of the arches, unscrew the screws that secure the sides of the rear bumper.
-we release the latch in the wings (pull the corners towards you).
-we release the latch in the opening of the trunk.
-with an assistant, gently pull the bumper back (look behind the wires).
-disconnect electrical connectors (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español