-
-
-
Front bumper
-under the hood, remove the grille (held by the latches).
-under the radiator grille and pull out the piston and Unscrew the two screws (twisted and inserted upside down).
-Unscrew the screws (spun down) and pull forward indexes of turns.
-under the turn signal, take out the caps.
-in the bottom part Unscrew the screws.
-wrenched the wheel left or right, depending on which side of the bed will disassemble.
-wheel arches vacated lockers and Unscrew one screw on each side (spun upwards) holding the corners to the wings.
-s the assistant pulls gently on the bumper itself.
-remove the connectors from the fog lights (if any).
Rear bumper
-in the wheel wells, Unscrew the screws and peel the fender liner.
-for wheel arch liners Unscrew one screw on each side (spun upwards) that secure the corner bumper to the wings.
-open the trunk lid and pulls in the opening four pistons (inserted upside down).
-at the bottom, Unscrew the screws and take out the caps (twisted and inserted from the bottom up) that secure the lower part.
-with the assistant gently pulls the bumper itself from the guides.
English 
Italiano 
Français 
русский 
Deutsch 
Español