-
-
-
Front bumper
-open the hood.
-take out the caps (inserted from top to bottom) that secure the radiator grille and upper bumper.
-remove the grille and take out beneath them two clips.
-at the bottom, take out the caps and Unscrew the screws (twisted and inserted from the bottom up).
-wrenched the wheel left or right, depending on which side of the bed will disassemble.
-wheel arches vacated lockers and Unscrew one screw on each side (spun upwards) holding the corners to the wings.
-with the assistant release the latch in the wings and bumper pulls gently on yourself.
-remove the connectors from the fog lights (if any).
-remove connector from the PDC (if any).
Rear bumper
-wheel arches, peel the fender liner.
-for wheel arch liners Unscrew one screw on each side (spun upwards) that secure the corner bumper to the wings.
-at the bottom, Unscrew the screws and take out the caps (twisted and inserted from the bottom up) that secure the lower part.
-open the boot lid and Unscrew the corners of the opening the screws.
-with the assistant release the latch in the wings and opening the trunk, gently pulls the bumper itself.
-remove the connectors from the equipment (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español