-under the hood, take out four cap (the inserted top to bottom) that secure the upper part.
-on the perimeter at the bottom of the bumper, Unscrew the screws and take out the caps (twisted and inserted from the bottom up).
-wrenched the wheel to the left or right side, depending on which side of the bed will be dismantled.
-in the wheel wells, Unscrew the screws and peel the fender liner.
-turn down the lockers to the side and release bumper fasteners in the wings.
-s the assistant pulls gently on the bumper itself.
-remove the connectors from the fog lights (if any).
-open the trunk lid.
-in the opening, Unscrew two screws on each side and remove the tail lights.
-Unscrew the screws under the rear lights.
-on the perimeter in the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up).
-wheel arches, peel the fender liner.
-remove the fender liner to the side and Unscrew one screw on each side holding the bumper corners to the wings.
-with the assistant gently pulls the bumper itself.
-remove connector from the PDC (if any).