Depending on the year of release of attachment is different.
-open the hood.
-under the hood released from latch and remove the grille.
-under the grille and pull out the caps (inserted from top to bottom) that secure the upper part.
-at the bottom, take out the caps and Unscrew the screws that attach the lower part.
-wrenched the wheel left or right, depending on which side of the bed will disassemble.
-in the wheel wells, Unscrew the screws and remove the caps, release the fender liner.
-the fender liner, Unscrew the screws that attach the bumper to the wings.
-with the assistant release the latch and gently pulls the bumper itself.
-remove the connectors from the fog lights (if any).
-remove connector from the PDC (if any).
-remove connectors with additional electrical equipment (if any).
-open the trunk lid.
-Unscrew the screws and remove the tail lights.
-under rear lights and opening boot Unscrew the seven screws (spun down).
-Unscrew the screws around the perimeter at the bottom.
-with the assistant release the bumper clips and gently pulls the bumper itself.
-remove the connectors from the equipment (if any).