Front bumper

-open the hood and remove six caps (inserted from top to bottom) that secure the grille and the upper bumper section.

-on the perimeter at the bottom of the bumper, Unscrew the screws and take out the caps (twisted and inserted from the bottom up).

-remove the wheel arches (attached to the latch, pull towards you).

-wrenched the wheel to the left or right side, depending on which side will dismantle.

-wheel arches, peel the fender liner.

-turn down the lockers to the side and Unscrew one screw on each side (spun upwards) holding the bumper to the wings.

-with the assistant release the latch in the wings and bumper pulls gently on yourself.

-remove the connectors from the fog lights (if any).

-if you have headlight washers, disconnect the hose (to fluid from the reservoir flowed to the ground, you must prepare the container or tube).

-if there are sensors, releasable connector.

the attachment of the front bumper of the Nissan Qashqai (Rogue) (2006-2013)

the scheme of fastening of the front bumper of the Nissan Qashqai (Rogue) (2006-2013)

Rear bumper

-open the lid, take out the plugs and Unscrew at the corners of the opening the screws.

-on the perimeter in the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up).

-release the wheel arches (attached to the latch, pull towards you).

-wheel arches, peel the fender liner.

-remove the fender liner to the side and Unscrew one screw on each side (spun up), which attach the angles to the wings.

-with the assistant release the latch in the wings (pull on yourself), and gently pulls the bumper itself.

-remove the connectors from the sensors (if any).

the attachment of the rear bumper Nissan Qashqai (Rogue) (2006-2013)

scheme of fastening of a back bumper of Nissan Qashqai (Rogue) (2006-2013)

 

How to remove front and rear bumper Nissan Qashqai (Rogue) (after 2013)