-
-
-
Depending on the year of manufacture, the mounting locations may vary slightly.
Front bumper
-open the hood.
-under the hood we take out the eight pistons (inserted from top to bottom) that secure the upper part of the radiator grille.
-release from the latches (pull towards you) and remove the radiator grille (pay attention to the electrical connector.
-under the radiator grille, take out the eight pistons (inserted from top to bottom) that secure the upper part of the front bumper.
-unscrew the ten screws (twisted from bottom to top) that secure the lower part.
-turn the wheels to the side.
-in the wheel arches we release the fender liners (front part).
-behind the fender liners, unscrew one screw on each side (twisted from bottom to top) that secure the corners of the bumper to the wings.
-release the latches in the wings (pull the corners toward you).
-with an assistant, carefully pull the bumper forward (watch the wires).
-disconnect the connectors of the electrical equipment (if any).
Rear bumper
-open the trunk lid.
-remove the covers near the rear lights (they are held on by clips, you need to pick them up and pull them towards you).
-under the trims, unscrew two screws on each side and remove the rear lights (they are held on by clips in the wings).
-under the rear lights, unscrew the two screws and take out the two pistons that secure the upper part of the rear bumper.
-from the bottom side, unscrew the screws (twisted from bottom to top) that secure the lower part.
-in the wheel arches, unscrew five screws on each side that secure the fender liners (rear part).
-move the fender liners to the side and Unscrew one screw on each side that secures the corners to the wings.
-release the latches in the wings (pull the corners toward you).
-with an assistant, pull the bumper back (watch the wires).
-disconnect the connectors of the electrical equipment (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español