Depending on the year of manufacture, the mounting locations may vary slightly.
Front bumper
-open the hood.
-under the hood we take out the six pistons (inserted from top to bottom) that secure the radiator grille and the upper part of the bumper. (if you need to remove the radiator grille separately from the corners of the grille with a flat screwdriver, through the holes, turn the plastic clips clockwise 90 degrees and pull them out towards you).
-unscrew the screws and pull out the pistons (twisted and inserted from bottom to top) along the perimeter at the bottom.
-turn the wheels to the left or right, depending on which side you will disassemble.
-in the wheel arches, unscrew one screw on each side that secures the plastic arch linings.
-we release the covers from the bumper (they are held on by latches, we pull them towards us from the bottom up).
-we release the fender liners (the front part and unscrew one screw on each side (twisted from bottom to top), which secure the corners of the bumper to the wings.
-release the latches in the wings (pull the corners toward you).
-release the latches under the headlights.
-with an assistant, pull the bumper forward (watch the wires and hoses).
-remove the connectors from the fog lights (if any).
-remove the connector from the parking sensors (if equipped).
-if there are headlight washers, disconnect the hoses (liquid may leak).
English 
Italiano 
Français 
русский 
Deutsch 
Español 
