Nissan Rogue I S35 (2007-2013) bumper removal.

Depending on the year of manufacture, the mounting locations may vary slightly.

Front bumper

-open the hood.

-under the hood we take out the eight pistons (inserted from top to bottom) that secure the upper part of the front bumper.

-from the bottom, unscrew the six screws that secure the fender liners and take out the six pistons that secure the engine compartment protection.

-turn the wheels to the side.

-in the wheel arches we release the fender liners (front part).

-move the fender liners to the side and unscrew one screw on each side (twisted from bottom to top) that secure the corners to the wings.

-release the latches in the wings (pull the corners toward you).

-with an assistant, carefully pull the bumper forward (watch the wires).

-disconnect the connectors of the electrical equipment (if any).

Rear bumper

-open the trunk lid.

-in the trunk opening, take out two plugs.

-under the plugs, unscrew the two screws that secure the upper part of the rear bumper.

-from the bottom, unscrew the two screws and take out the five pistons (twisted and inserted from the bottom up) that secure the lower part.

-unscrew the screws in the wheel arches and release the fender liners (rear part).

-move the fender liners to the side and unscrew one screw on each side (twisted from bottom to top) that secure the corners to the wings.

-release the latches in the wings (pull the corners toward you).

-with an assistant, pull the bumper back (watch the wires).

-disconnect the connectors of the electrical equipment (if any).

Nissan Rogue II T32 (2013-2020) bumper removal.