-
-
-
Depending on the model year and body type of attachment may vary.
Front bumper
-open the hood.
-between the headlights and pull out the caps (inserted from top to bottom) that secure the upper part.
-at the bottom, take out the caps and Unscrew the screws (twisted and inserted from the bottom up) that secure the lower part of the bumper.
-wrenched the wheel left or right, depending on which side of the bed will disassemble.
-wheel arches, release the fender liner.
-Unscrew one screw on each side (spun upwards) holding the bumper to the wings.
-attach the fender liner to the side and twisted in the wings on a nut on each side under the taillights.
-release the clips under the headlights.
-s the assistant pulls gently on the bumper itself.
-remove the connectors from the fog lights (if any).
-remove connector from the PDC (if any).
Rear bumper
-open the boot lid and Unscrew the aperture screws (spun down).
-in the trunk, we release the side trim (you need to access the rear part of the rear lights).
-for casings, Unscrew the nuts and remove the tail lights.
-the rear lights take out the caps (inserted upside down).
-from the trunk, Unscrew the nuts that attach the bumper to the wings.
-Unscrew the screws and take out the caps on the perimeter at the bottom.
-wheel arches Unscrew the screws that attach the angles to the wings (spun up).
-assistant exempt the bumper and gently pulls on itself.
-remove the connectors from the equipment (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español