Depending on the year the attachment is different
-under the hood, take out the four clips and remove the grille (held by the latches).
-under the grille pulls out three clips that secure the upper part of the bumper.
-in the lower part of the bumper take out the caps and Unscrew the screws (twisted and inserted from the bottom up) that secure the lower part.
-wrenched the wheel left or right, depending on which side of the bed will disassemble.
-in the wheel wells, Unscrew the screws and take out the rivets that attach the fender liner.
-turn down the lockers to the side and Unscrew the screws that attach the bumper to the wings.
-with the assistant release the latch in the wings and bumper pulls gently on yourself.
-remove the connectors from the fog lights (if any).
-remove connectors with additional electrical equipment (if available).
-open the trunk lid.
-in the opening, Unscrew two screws on each side and remove the tail lights (hold on clips).
-the rear lights we release the plastic latches.
-Unscrew the screws in the opening of the trunk.
-remove the pad (pull on itself, rests on the latch).
-under the panel and pull out the caps (inserted upside down).
-in the wheel wells, Unscrew the screws and take out the rivets holding the mudguards and wheel arches (not to remove the wheels easier to turn a ratchet with a nozzle).
-remove the fender liner to the side and Unscrew one screw on each side (spun upwards) holding the corners to the wings.
-on the perimeter in the bottom part Unscrew the screws and take out the caps.
-with the assistant release the bumper clips and gently pulls on itself.
-remove the connectors from the equipment (if any).