-
-
-
Nissan Altima III (L31) (2001-2006)
Front bumper
-open the hood.
-take out the caps (inserted upside down) and remove the grille.
-unscrew the screws that attach the top part of the bumper.
-at the bottom, take out the caps and unscrew the screws (twisted and inserted from the bottom up).
-wrenched the wheel left or right, depending on which side of the bed will disassemble.
-wheel arches vacated lockers and Unscrew one screw on each side (spun upwards) holding the corners to the wings.
-s the assistant pulls gently on the bumper itself.
-remove the connectors from the fog lights (if any).
-remove connector from the PDC (if any).
Rear bumper
-in the trunk take out the caps and remove the side trim.
-for casings, Unscrew the nuts and remove the tail lights.
-the rear lights take out the caps.
-the skins in the wings, Unscrew one nut and one screw on each side.
-wheel arches take out the rivets and removed the fender liner.
-for wheel arch liners Unscrew one screw on each side (spun upwards) that secure the corner bumper to the wings.
-at the bottom, Unscrew the screws and take out the caps (twisted and inserted from the bottom up) that secure the lower part.
-with the assistant release the latch in the wings and opening the trunk, gently pulls the bumper itself.
-remove the connectors from the equipment (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español