Depending on the year of release of the attachment can vary.
Front bumper
-open the hood and remove the rivets that secure the grille.
-at the bottom, take out the caps and Unscrew the screws (twisted and inserted from the bottom up) that secure the lower part.
-mishelkevin moldings of the bumper (pull towards you).
-under moldings Unscrew one screw on each side that attach the angles to the wings.
-wrenched the wheel left or right, depending on which side of the bed will disassemble.
-wheel arches take out the caps, release the fender liner.
-with the assistant release the latch in the wings and bumper pulls gently on yourself.
-remove the connectors from the equipment (if any).
Rear bumper
-open the trunk lid.
-in the opening under the plugs, Unscrew two screws on each side.
-Unscrew the screws and take out the caps on the perimeter at the bottom.
-we release latches (pull on) to the moldings in the wheel arches.
-under moldings, Unscrew the screws holding the corners of the bumper to the wings.
-wheel arches take out the rivets that attach the fender liner.
-assistant free the bumper from the clips in the wings and gently pulls on itself.
-remove connectors from electrical equipment.