Depending on the model year and model type, the attachment may vary.

Front bumper

-open the hood and Unscrew the screws and take out the caps (inserted and twisted from the top down), remove the air intake.

-under the hood, Unscrew the screws and take out the clips that secure the grille.

-release the screen from the latches and remove.

-under the grille and pull out the piston.

-around the bottom part Unscrew the screws (spun up).

-wrenched the wheel to the left or right side depending on which side we will analyze first.

-in the wheel arches to turn out screws and take out the clips holding the fender liner.

-assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves.

-remove the connector from the fog lamp (if any).

-remove connector from the PDC (if any).

-if you have headlight washers, disconnected the hoses (so the liquid will not escape on earth, should prepare a special container).

scheme of fastening of the radiator grille Toyota Highlander XU 40 (2008-2013)

the scheme of fastening of the front bumper 40 XU Toyota Highlander (2008-2013)

the scheme of fastening of the front bumper 40 XU Toyota Highlander (2008-2013)

Rear bumper

-open the boot lid and twisted in the opening one screw on each side.

-on the perimeter in the bottom part Unscrew the screws and remove clips (twisted and inserted from the bottom up).

-Unscrew the screws in the wheel arches that secure the fender liner.

-assistant free the bumper from the clips in the wings and under the tail lamps.

-pulls from the guides themselves.

-remove connector from the PDC (if any).

-remove connectors with additional equipment (if any).

diagram of rear bumper Toyota Highlander XU 40 (2008-2013)

diagram of rear bumper Toyota Highlander XU 40 (2008-2013)