-
-
-
Toyota Corolla XI (E160, E170) (2012-2022)
Depending on the model year and model type, the attachment may vary.
Front bumper
-under the hood, Unscrew the screws and remove clips (twisted and inserted top to bottom) and remove the grille.
-under the grille, take out the clips (inserted upside down).
-around the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up) that secure the bumper to the defense.
-wrenched the wheel to the left or right side depending on which side we will analyze first.
-in the wheel arches and take out the clips wrenched the screws.
-assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves.
-remove the connector from the fog lamp (if any).
-Remove the connector from the parking sensors (if any).
-if you have headlight washers, disconnected the hoses (so the liquid will not escape on earth, should prepare a special container).
Rear bumper
-open the boot lid and twisted in the opening one screw on each side.
-in the wheel wells, Unscrew the screws and take out the rivets that attach the fender liner.
-for wheel arch liners Unscrew one screw on each side (spun up).
-on the perimeter in the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up).
-assistant free the bumper from the clips in the wings and under the tail lamps.
-pulls from the guides themselves.
-remove connector from the PDC (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español