How to remove front and rear bumper Toyota Picnic

Front bumper

-open the hood and remove the front strap three clips that secure the upper part of the bumper.

-around the bottom part Unscrew the screws (spun up).

-wrenched the wheel to the left or right side depending on which side we will analyze first.

-in the wheel arches and take out the clips wrenched the screws that attach the fender liner to the bumper.

-attach the fender liner to the side and Unscrew one screw on each side (spun up), which attach the angles to the wings.

-with the assistant remove a bumper from the guides themselves.               

-remove the connector from the fog lamp (if any).

-remove connector from the PDC (if any).

-if you have headlight washers, disconnected the hoses (so the liquid will not escape on earth, should prepare a special container or bend the hose).

Rear bumper

-open the trunk lid and in the opening and pull out the caps (inserted upside down).

-in the wheel wells, Unscrew the screws and take out the rivets that attach the fender liner and mud flaps (if any).

-attach the fender liner to the side and Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.

-on the perimeter in the bottom part Unscrew the screws (and spun up).

-with the assistant release the latch in the wings and pulls the bumper from the guides themselves.

-remove connector from the PDC (if any).

-remove connectors with additional electrical equipment (if any).