Front bumper

Depending on the model year and model type, the attachment may differ.

-open the hood and Unscrew the screws (spun down).

-remove the grille and Unscrew the screw under it.

-remove the direction indicators (need to pry with a screwdriver the latch and pull the turn signal out).

-Unscrew one screw on each side in the opening direction indicators.

-under the car, Unscrew the screws around the perimeter (spun up) that secure the lower part.

-wrenched the wheel to the left or right side depending on which way we will analyse it first.

-wheel arches Unscrew the screws that attach the fender liner.

-pushed aside and wrenched the wheel arches on each side one screw (spun upwards) holding the corners to the wings.

-with the assistant pulls the bumper from the guides themselves.

-if you have headlight washers, disconnected the hoses. Should prepare a container under the wiper.

-remove connector from the PDC (if any).

-remove the connector from the fog lamp (if any).

the attachment of the front bumper Toyota Avensis MK1 (1997 - 2003)

the scheme of fastening of the front bumper Toyota Avensis MK1 (1997 - 2003)

Rear bumper

Depending on the model year and model type, the attachment is different.

-open the boot lid and Unscrew the aperture screws.

-remove the plastic cover of the rear panel and Unscrew the nuts underneath (need head with extension). In the universal and even the screws in the opening of the trunk in the corners.

-wheel arches Unscrew the screws that attach the fender liner.

-move the wing flaps to the side and Unscrew one screw on each side (spun upwards) holding the corners to the wings .

-take out the caps and Unscrew the screws on the perimeter in the lower part (inserted and spun up) (can only be screws).

-assistant release bumper latches and pulls from the guides themselves.

-if you have sensors, remove the connector.

diagram of rear bumper Toyota Avensis MK1 (1997 - 2003)

diagram of rear bumper Toyota Avensis MK1 (1997 - 2003)