-
-
-
Toyota Yaris XP210 (2020+)
Front bumper
-open the hood.
-under the hood take out the caps and unscrew the screws that secure the upper part of the bumper (radiator grille).
-around the perimeter of the lower part, unscrew the screws and take out the caps that secure the protection and fender liner.
-turn the wheels to the side.
-in the wheel arches, release the clips that secure the fender liner (front).
-take out one piston on each side that attach the corners of the bumper to the wings.
-we release the latch in the wings (pull the corners of the bumper towards you).
-with an assistant, pull the bumper forward (look for the wires).
-disconnect electrical connectors.
Rear bumper
-open the trunk lid.
-in the opening of the trunk, unscrew the two screws.
-in the wheel wells take out the caps and unscrew the screws that secure the fender liner (rear) and bumper corners to the wings.
-at the bottom of the bumper take out six caps (inserted from the bottom up).
-we release the latches in the wings and under the rear lights (pull the corners of the bumper towards you).
-with an assistant, pull the bumper back (look for the wires).
-disconnect electrical connectors (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español