-
-
-
Depending on the model year and model type, the attachment may vary.
Front bumper
-under the hood, take out the clips and remove the grille (the lower part rests on the latch).
-around the bottom part Unscrew the screws (spun up).
-wrenched the wheel to the left or right side depending on which side we will analyze first.
-in the wheel arches to turn out screws and take out the clips holding the fender liner.
-for wheel arch liners Unscrew one screw on each side (spun up).
-assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves.
-remove the connector from the fog lamp (if any).
-remove connector from the PDC (if any).
-if you have headlight washers, disconnected the hoses (so the liquid will not escape on earth, should prepare a special container).
Rear bumper
-open the boot lid and Unscrew the aperture screws and take out the caps.
-remove rear trim (attached with snaps).
-under the casing Unscrew the four nuts (need head ratchet).
-on the perimeter in the bottom part Unscrew the screws and remove clips (twisted and inserted from the bottom up).
-Unscrew the screws in the wheel arches that secure the fender liner.
-assistant release bumper latches in the wings.
-pulls from the guides themselves.
-remove connector from the PDC (if any).
-remove connectors with additional equipment (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español