How to remove front and rear bumper Toyota Avalon (2005-2012)
Front bumper
Depending on the model year and model type, the attachment is different.
-open the hood, Unscrew the screws and take out the caps (twisted and inserted top to bottom) that attach the bumper and grille to the top of the bar.
-Unscrew the screws on the perimeter in the bottom (spun up).
-wrenched the wheel to the left or right side depending on which side we will analyze first.
-in the wheel wells, Unscrew the screws and take out the rivets that attach the fender liner.
-move the wing flaps to the side and Unscrew one screw on each side (spun up), which attach the angles to the wings.
-with the aide of tear the corners with the locks in the wings and pulls the bumper from the guides themselves.
- if you have headlight washers, detach the hoses from the injectors. The liquid leaking on the ground, you need to prepare a suitable container or tube.
-remove connector from the PDC (if any).
-remove the connector from the fog lamp (if any).
Rear bumper
-in the trunk remove the plastic cover of the rear panel.
-under the trim, Unscrew the screws and nuts.
-in the wheel wells, Unscrew the screws and take out the caps.
-move the wing flaps to the side and Unscrew one screw on each side (spun upwards) holding the corners to the wings.
-take out the caps and Unscrew the screws on the perimeter in the lower part (inserted and spun up).
-assistant free the bumper from the clips in the wings and pulled off of the guide itself.
-remove the electrical connector license plate light.
English 
Italiano 
Français 
русский 
Deutsch 
Español 
