How to remove front and rear bumper Toyota Prius (2009-2015)
Toyota Prius III XW30 (2009-2015)
Depending on the model year and model type, the attachment may vary slightly.
Front bumper
-open the hood and remove the trim above the radiator (attached with snaps).
-under the pickguard, Unscrew the screws and remove clips (twisted and inserted top to bottom) that secure the upper part of the bumper .
-around the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up).
-wrenched the wheel to the left or right side depending on which side we will analyze first.
-in the wheel arches and take out the clips wrenched the screws that attach the fender liner to the bumper.
-assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves.
-remove the connector from the fog lamp (if any).
-remove connector from the PDC (if any).
-if you have headlight washers, disconnected the hoses (so the liquid will not escape on earth, should prepare a special container).
Rear bumper
-open the trunk lid and the opening in the corners pulls the plug.
-under the plugs, Unscrew the screws.
-in the wheel wells, Unscrew the screws and take out the clips holding the wheel arch liners (to remove the wheels easier to twist a ratchet with a nozzle).
-attach the fender liner to the side and twisted at the corners with one screw on each side (if any).
-on the perimeter in the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up).
-assistant free the bumper from the clips in the fenders, under the rear lights and opening boot.
English 
Italiano 
Français 
русский 
Deutsch 
Español 
