-
-
-
Depending on the model year and model type, the attachment may vary slightly.
Front bumper
-under the hood take out the rivets and remove the plate.
-under the pickguard, Unscrew the screws and take out the clips that secure the grille and top of bumper to top plate.
-around the bottom part Unscrew the screws (spun up).
-wrenched the wheel to the left or right side depending on which side we will analyze first.
-wheel arches take out the clips holding the fender liner to the bumper.
-attach the fender liner to the side and Unscrew one screw on each side holding the bumper corners to the wings.
-assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves.
-remove the connector from the fog lamp (if any).
-remove connector from the PDC (if any).
-if you have headlight washers, disconnected the hoses (so the liquid will not escape on earth, should prepare a special container).
Rear bumper
-open the boot lid in the opening, Unscrew the four screws on the threshold (spun down) and the screws near the tail lights.
-in the wheel wells, Unscrew the screws holding the wheel arch liners (to remove the wheels easier to twist a ratchet with a nozzle).
-on the perimeter in the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up).
-attach the fender liner to the side and twisted at the one screw on each side that attach the bumper to the wings (spun up) (may not be).
-assistant free the bumper from the clips in the wings and shoot on himself (the door should be half open).
-remove connector from the PDC (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español