Toyota Highlander XU50 (2013-2019)

Depending on the year of manufacture, the attachment points may vary slightly.

Front bumper

-open the hood.

-under the hood take out the caps and remove the trim over the grille.

-take out the four pistons that secure the grille.

-take out the three pistons behind the grille.

-unscrew the screws around the perimeter of the lower part of the bumper (spun up).

-turn the wheels depending on which side we will disassemble.

-in the wheel wells, take out the caps and Unscrew the screws that secure the fender lining, fender liner and side of the bumper.

-we release the lining of the wings from the bumper (hold on the latches, pull towards you).

-we release the latch in the wings (pull the corners of the bumper towards you).

-with an assistant, pull the bumper forward (look for the wires).

-disconnect electrical connectors (if any).

front bumper attachment points Toyota Highlander XU50 (2013-2019)

Front bumper mounting scheme Toyota Highlander XU50 (2013-2019)

 

Rear bumper

-open the trunk lid.

-unscrew the two screws in the opening of the trunk.

-around the bottom of the bumper take out the caps and Unscrew the screws.

-take out the caps and Unscrew the screws in the wheel wells that secure the fender liner, fender liner and side of the bumper.

-we release the lining of the wings from the bumper (hold on the latches, pull towards you).

-we release the latch in the wings (pull the corners of the bumper towards you).

-with an assistant, pull the bumper back (look for the wires).

-disconnect electrical connectors.

rear bumper attachment points Toyota Highlander XU50 (2013-2019)

Rear bumper mounting scheme Toyota Highlander XU50 (2013-2019)