How to remove front and rear bumper Toyota Aygo (2005-2014)

Front bumper

Depending on the year of release of the attachment can vary.

-under the hood, Unscrew two screws and remove two pistons (twisted and inserted top to bottom) that secure the grille to the top of the bar.

-under the car, Unscrew the screws around the perimeter (spun up) that secure the lower part.

-wrenched the wheel to the left or right side depending on which side we will analyze first.

-wheel arches Unscrew the screws that attach the fender liner.

-pushed aside and wrenched the wheel arches on each side one screw (twisted up) (can be caps) that attach the angles to the rails.

-with the aide of tear clips in the wings and pulls the bumper from the guides themselves.

-if you have headlight washers, disconnected the hoses. Should prepare a container under the wiper.

-remove connector from the PDC (if any).

-remove the connector from the fog lamp (if any).

Rear bumper

Depending on the year of release of attachment is different.

-open the boot lid and twisted in the opening one screw on each side near the rear lights.

-in the boot remove the side trim (you need to access the rear part of the rear lights).

-Unscrew the nuts and remove the tail lights.

-take out the clips under the rear lights.

-wheel arches Unscrew the screws that attach the fender liner.

-move the wing flaps to the side and take out one piston on each side that attach the angles to the rails.

-take out the caps and Unscrew the screws on the perimeter in the lower part (inserted and spun up) (can only be caps).

-assistant release bumper latches and pulls from the guides themselves.

-remove the electrical connector license plate light.

-if you have sensors, remove the connector.

How to remove the front and rear bumper Toyota Aygo (2015-2021)