How to remove front and rear bumper Toyota FJ Cruiser

Depending on the model year and model type, the attachment may vary.

Front bumper

-under the hood, Unscrew the screws, remove the clips and remove the grille.

-under the grille, Unscrew the five screws (spun down).

-around the bottom part Unscrew the screws (spun up).

-wrenched the wheel to the left or right side depending on which side we will analyze first.

-in the wheel wells of gut-wrenching screws.

-assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves.

-remove the connector from the fog lamp (if any).

-remove connector from the PDC (if any).

-if you have headlight washers, disconnected the hoses (so the liquid will not escape on earth, should prepare a special container).

Rear bumper

-open the boot lid and Unscrew the aperture screws (spun up).

-on the perimeter in the bottom part Unscrew the screws (spun up).

-take out the rivets in the wheel arches that secure the fender liner.

-assistant free the bumper from the clips in the wings and under the tail lamps.

-pulls from the guides themselves.

-remove connector from the PDC (if any).

-remove connectors with additional equipment (if any).