How to remove front and rear bumper Toyota Sienna XL30 (2010-2020)

Depending on the model year and model type, the attachment may vary.

Front bumper

-under the hood take out the caps ( inserted from top to bottom) that secure the grille.

-we release the bottom portion of the latches and remove the grille.

-around the bottom part Unscrew the screws (spun up).

-wrenched the wheel to the left or right side depending on which side we will analyze first.

-in the wheel wells, Unscrew the screws and take out the rivets that attach the fender liner to the bumper.

-assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves.

-remove the connector from the fog lamp (if any).

-remove connector from the PDC (if any).

-if you have headlight washers, disconnected the hoses (so the liquid will not escape on earth, should prepare a special container).

Rear bumper

-open the trunk lid.

-in the corners of the opening and pull out the plugs and Unscrew under them two screws on each side.

-in the wheel wells, Unscrew the screws and take out the clips holding the wheel arch liners and splash guards to the bumper (so as not to remove the wheel remove ratchet with a nozzle).

-on the perimeter in the bottom part Unscrew the screws (spun up).

-assistant free the bumper from the clips in the wings and shoot on themselves.

-remove connector from the PDC (if any).

-remove connectors with additional equipment (if any).

How to remove front and rear bumper Toyota Sienna XL10 (1997-2002)

How to remove front and rear bumper Toyota Sienna XL20 (2003-2010)