Depending on the model year and model type, the attachment is different.

Front bumper

-under the hood, Unscrew the two screws and take out the piston (twisted and inserted top to bottom) that secure the grille.

-we release the latch in the bumper and remove the grille.

-around the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up).

-wrenched the wheel to the left or right side depending on which side we will analyze first.

-wheel arches Unscrew the screws that attach the fender liner.

-move the wing flaps to the side and Unscrew one screw on each side that attach the angles to the wings.

-assistant exempt corners of the latches and remove the bumper from the guides themselves.

-remove the connector from the fog lamp (if any).

-remove connector from parkonika (if any).

-if you have headlight washers, disconnected the hoses.

the attachment of the front bumper Toyota Corolla (2000-2006)

the scheme of fastening of the front bumper Toyota Corolla (2000-2006)

the scheme of fastening of the front bumper Toyota Corolla (2000-2006)

Rear bumper

-in the trunk, Unscrew the screws and remove the back and side plating.

-for casings, Unscrew the four nuts (need head ratchet), one near the rear lights and two in the rear.

-wheel arches take out the rivets that attach the fender liner.

-move the wing flaps to the side and Unscrew one screw on each side that attach the angles to the wings.

-on the perimeter in the lower part and pull out the caps (inserted from the bottom up).

-assistant free the bumper from the clips in the wings and pulled off of the guide itself.

-remove connector from the PDC (if any).

the attachment of the rear bumper Toyota Corolla (2000-2006)

diagram of rear bumper Toyota Corolla (2000-2006)

diagram of rear bumper Toyota Corolla (2000-2006)