-
-
-
Toyota Corolla XII (E210) (2019+)
Depending on the year of manufacture, the attachment points may vary slightly.
Front bumper
-open the hood.
-under the hood take out the caps and remove the trim over the grille.
-under the trim, Unscrew the three screws (take out the caps, depends on the year of manufacture).
-behind the grille, release the electrical connector.
-at the bottom of the bumper, Unscrew ten screws (spun up).
-turn the wheels to the side.
-in the wheel arches, take out one piston and release two latches on each side.
-we release the latch in the wings (pull the corners of the bumper towards you).
-with an assistant, pull the bumper forward (look for the wires).
-disconnect electrical connectors (if any).
Rear bumper
-open the trunk lid.
-near the rear lights, remove the pads (hold on latches, you need to pry with a flat screwdriver).
-under the covers, Unscrew the two screws.
-around the perimeter of the lower part of the bumper take out the caps.
-take out the caps in the wheel arches.
-we release the latches in the wings and under the rear lights (pull the corners of the bumper towards you).
-with an assistant, pull the bumper back (look for the wires).
-disconnect electrical connectors (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español