Depending on the model year and model type, the attachment may vary.

Front bumper

-under the hood take out the rivets and remove the plate.

-under the pickguard, Unscrew the screws and take out the clips that secure the grille and top of bumper to top plate.

-around the bottom part Unscrew the screws (spun up).

-wrenched the wheel to the left or right side depending on which side we will analyze first.

-wheel arches take out the clips and Unscrew the screws that attach the fender liner to the bumper.

-assistant exempt corners of the latches in the wings and under the headlights, remove the bumper from the guides themselves.

-remove the connector from the fog lamp (if any).

-remove connector from the PDC (if any).

-if you have headlight washers, disconnected the hoses (so the liquid will not escape on earth, should prepare a special container).

the attachment of the front bumper of Toyota RAV4 (after 2012)

the scheme of fastening of the front bumper of Toyota RAV4 (after 2012)

Rear bumper

-open the trunk lid and the opening in the corners pulls the plug.

-under the plugs, Unscrew the screws.

-in the wheel wells, Unscrew the screws and take out the clips holding the wheel arch liners (to remove the wheels easier to twist a ratchet with a nozzle).

-on the perimeter in the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up).

-assistant free the bumper from the clips in the wings and shoot on themselves.

-remove connector from the PDC (if any).

-remove connectors with additional equipment (if any).

the attachment of the rear bumper Toyota RAV4 (after 2012)

diagram of rear bumper of Toyota RAV4 (after 2012)