-
-
-
Front bumper
-under the hood take out the seven rivets and remove the plastic panel.
-under panel, Unscrew the three screws and take out two pistons (twisted and inserted top to bottom) that secure the upper part of the bumper.
-in the lower part, Unscrew the six screws (spun up).
-wrenched the wheel to the left or right side depending on which side we will analyze first.
-wheel arches take out the rivets that attach the fender liner.
-pushed aside and wrenched the wheel arches on each side one screw (spun upwards) holding the corners to the wings.
-with the assistant release the latch in the wings and remove the bumper from the guides themselves.
-if you have headlight washers, disconnected the hoses (hose will need to bend either to drain fluid into a container).
-remove connector from the PDC (if any).
-remove the connector from the fog lamp (if any).
Rear bumper
Depending on the model year and model type, the attachment may vary.
-open the trunk lid and over the opening, near the rear lights, remove the plugs.
-under the plugs, Unscrew the screws.
-wheel arches Unscrew the screws that attach the fender liner.
-move the wing flaps to the side and Unscrew one screw on each side that attach the angles to the wings.
-Unscrew the screws around the perimeter in the bottom (spun up).
-assistant free the bumper from the clips in the wings and under the rear lights, pulled off of the guide itself.
-if you have sensors, remove the connector.
English 
Italiano 
Français 
русский 
Deutsch 
Español