Depending on the model year and model type, the attachment may vary.

Front bumper

-under the hood, Unscrew the screws and take out the caps (twisted and inserted top to bottom) that secure the top part of the bumper and the grille.

-around the bottom part Unscrew the screws (spun up).

-wrenched the wheel to the left or right side depending on which side we will analyze first.

-in the wheel wells, Unscrew the screws and take out the rivets that attach the fender liner to the bumper.

-move the wing flaps to the side and Unscrew one the screws on each side (spun upwards) holding the corners to the wings.

-assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves.

-remove the connector from the fog lamp (if any).

-remove connector from the PDC (if any).

-if you have headlight washers, disconnected the hoses (so the liquid will not escape on earth, should prepare a special container).

the attachment of the front bumper Toyota Solara

the scheme of fastening of the front bumper Toyota Solara

Rear bumper

-open the trunk lid.

-in the trunk remove the rear valance.

-under the casing Unscrew the four nuts (need head ratchet).

-in the wheel wells, Unscrew the screws holding the wheel arch liners and splash guards to the bumper (so as not to remove the wheel remove ratchet with a nozzle).

-on the perimeter in the lower part and pull out the caps (inserted from the bottom up).

-assistant release bumper latches in the wings and under the taillights, remove from the guides themselves.

-remove connector from the PDC (if any).

-remove connectors with additional equipment (if any).

the attachment of the rear bumper Toyota Solara

diagram of rear bumper Toyota Solara