Depending on the model year and model type, the attachment may vary slightly.

Front bumper

-open the hood and Unscrew the screws that attach the grille and the front panel.

-at the bottom, release the clips and remove the grille.

-under the grille, Unscrew the screws.

-between the wings and the panel with a flat head screwdriver release the latches and remove the panel.

-around the bottom part Unscrew the screws (spun up).

-wrenched the wheel to the left or right side depending on which side we will analyze first.

-wheel arches wrenched the screws that attach the fender liner to the bumper.

-attach the fender liner to the side and Unscrew one screw on each side holding the bumper corners to the wings.

-assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves.

-remove the connector from the fog lamp (if any).

-remove connector from the PDC (if any).

-if you have headlight washers, disconnected the hoses (so the liquid will not escape on earth, should prepare a special container).

the attachment of the front bumper Toyota RAV4 CA20W  (2000-2005)

the scheme of fastening of the front bumper CA20W Toyota RAV4 (2000-2005)

Rear bumper

-open the trunk lid and in the opening, Unscrew two screws on each side.

-in the wheel wells, Unscrew the screws holding the wheel arch liners (to remove the wheels to twist the ratchet head) and Unscrew one screw on each side holding the corners of the parts of the bumper to the wings (spun up).

-at the bottom, Unscrew the screws (spun up).

-assistant exempt section of the bumper from the clips in the wings and shoot on themselves.

-remove connector from the PDC (if any).

the attachment of the rear bumper Toyota RAV4  (2000-2005)

the scheme of fastening of the rear bumper Toyota RAV4  (2000-2005)