How to remove front and rear bumper Toyota Sequoia (2008-2022)

Depending on the model year and model type, the attachment may vary.

Front bumper

-open the hood.

-under the lights Unscrew two screws on each side and remove the pads.

-take out the rivets that attach the upper bumper section (inserted upside down).

-around the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up).

-wrenched the wheel to the left or right side depending on which side we will analyze first.

-wheel arches Unscrew the screws that attach the fender liner and lining to the bumper.

-move the wing flaps to the side and Unscrew one screw on each side (spun upwards) holding the corners to the wings.

-assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves.

-remove the connector from the fog lamp (if any).

-remove connector from the PDC (if any).

-if you have headlight washers, disconnected the hoses (so the liquid will not escape on earth, should prepare a special container).

Rear bumper

-open the boot lid and Unscrew the aperture screws.

-in the wheel wells, Unscrew the screws and take out the clips holding the wheel arch liners and splash guards to the bumper (so as not to remove the wheel remove ratchet with a nozzle).

-attach the fender liner to the side and Unscrew one screw on each side that attach the angles to the wings (may not be).

-on the perimeter in the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up).

-assistant free the bumper from the clips in the wings and shoot on themselves.

-remove connector from the PDC (if any).

-remove connectors with additional equipment (if any).

How to remove front and rear bumper Toyota Sequoia (2001-2007)