How to remove front and rear bumper Toyota Tundra (after 2007)

Depending on the model year and model type, the attachment may vary.

Front bumper

-wrenched the wheel to the left or right side depending on which side we will analyze first.

-in the wheel wells, Unscrew the screws and take out the rivets that attach the fender liner to the bumper.

-move the wing flaps to the side, Unscrew the screws and remove the caps holding the corners of the lining to the wings.

-open the hood, Unscrew two screws on each side under the headlights and remove the lining.

-on the perimeter in the upper part Unscrew the screws and take out the caps (twisted and inserted upside down).

-remove the cover of the bumper underneath and Unscrew two screws on each side (twisted upside down).

-around the bottom part Unscrew the screws (spun up).

-assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves.

-remove the connector from the fog lamp (if any).

-remove connector from the PDC (if any).

-if you have headlight washers, disconnected the hoses (so the liquid will not escape on earth, should prepare a special container).

Rear bumper

-in the middle of the Central pads of the bumper, Unscrew the screw.

-free pads the bumper from the latches and remove.

-under the covers, Unscrew the screws (spun down).

-at the bottom, Unscrew the two screws (spun up).

-with the assistant remove a bumper from the guides themselves.

-remove connector from the PDC (if any).

-remove connectors with additional equipment (if any).

How to remove front and rear bumper Toyota Tundra (2000-2006)