Depending on the model year and model type, the attachment may vary.

Front bumper

-under the hood, Unscrew the screws and remove clips (twisted and inserted top to bottom) that secure the top part of the bumper (the grille).

-Unscrew the screws in the lower grille (may not be).

-around the bottom part Unscrew the screws (spun up).

-wrenched the wheel to the left or right side depending on which side we will analyze first.

-in the wheel arches and take out the clips wrenched the screws.

-move the wing flaps to the side and Unscrew the screws that attach the angles to the wings.

-assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves.

-remove the connector from the fog lamp (if any).

-remove connector from the PDC (if any).

-if you have headlight washers, disconnected the hoses (so the liquid will not escape on earth, should prepare a special container).

the attachment of the front bumper of the Toyota Previa

the scheme of fastening of the front bumper of the Toyota Previa

Rear bumper

-open the boot lid and twisted in the opening one screw on each side (may not be).

-in the trunk remove the rear valance.

-under the skin Unscrew the nut (will need a head with a ratchet).

-in the wheel wells, Unscrew the screws and take out the rivets that attach the fender liner and mud flaps (if any).

-attach the fender liner to the side and twisted at the corners with one screw on each side.

-on the perimeter in the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up).

-assistant free the bumper from the clips in the wings and under the tail lamps.

-pulls from the guides themselves.

-remove connector from the PDC (if any).

the attachment of the rear bumper of the Toyota Previa

diagram of rear bumper Toyota Previa