How to remove front and rear bumper Toyota Urban Cruiser

Front bumper

-wrenched the wheel to the left or right side depending on which side we will analyze first.

-in the wheel wells, Unscrew the screws and take out the rivets that attach the fender liner to the bumper and the bumper to the wings.

-open the hood and take out the caps (inserted from top to bottom) that secure the upper part.

-around the bottom part Unscrew the screws (spun up).

-assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves.

-remove the connector from the fog lamp (if any).

-remove connector from the PDC (if any).

-if you have headlight washers, disconnected the hoses (so the liquid will not escape on earth, should prepare a special container).

Rear bumper

-open the trunk lid.

-in the opening of the trunk under the tail lights and pull out plugs.

-under the plugs, Unscrew one screw on each side.

-wheel arches take out the rivets that attach the fender liner to the bumper.

-on the perimeter in the lower part and pull out the caps (inserted from the bottom up).

-assistant free the bumper from the clips in the wings and under the tail lamps, remove from the guides themselves.

-remove connector from the PDC (if any).

-remove connectors with additional equipment (if any).