-
-
-
Chevrolet Corvette C6 (2005-2013)
Depending on the year of manufacture, the mounting locations may vary slightly.
How to remove the front bumper
-open the hood.
-under the hood, unscrew the four screws that secure the upper part of the front bumper (twisted from the side of the engine compartment).
-from the bottom side, unscrew the eleven screws (twisted from bottom to top) that secure the lower part.
-turn the wheels left or right depending on which side we will disassemble first.
-in the wheel arches we take out the pistons that secure the fender liners (front part).
-behind the fender liners, unscrew two nuts on each side (twisted from bottom to top, which secure the sides to the wings.
-we release the sides from the studs in the wings (pull down).
-release the fasteners under the hood (pull up).
-we release the connectors of the direction indicators and fog lights.
-with an assistant, pull the bumper forward (pay attention to the upper part so as not to damage the bumper on the hood).
How to remove the rear bumper
-open the trunk lid.
-Unscrew the six screws (spun from top to bottom) that secure the upper part of the front bumper.
-from the bottom, unscrew ten screws (twisted from bottom to top) that secure the lower part.
-remove the license plate.
-under the license plate, unscrew the two screws.
-unscrew one screw on each side and remove the rear lights (closest to the wings).
-through the openings of the rear lights, Unscrew two screws on each side that secure the sides to the wings.
-take out the pistons and unscrew the screws in the wheel arches and release the fender liners (rear part).
-behind the fender liners, Unscrew one screw and two nuts on each side that secure the sides to the wings.
-release the latches at the top (pull up).
-with an assistant, remove the bumper from the guides backwards (make sure not to break the wires.
-remove the connectors from the electrical equipment.
English 
Italiano 
Français 
русский 
Deutsch 
Español