Depending on the model year and body type of attachment are different.

Front bumper

-open the hood.

-under the hood take out the caps (can be screws) that secure the upper part.

-wrenched the wheel to the left or right side depending on which side we will analyze first.

-wheel arches Unscrew three screws on each side holding the fender liner.

-attach the fender liner to the side and Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.

-on the perimeter in the lower part and pull out the caps and Unscrew the screws (twisted and inserted from the bottom up).

-assistant exempt corners of the latches in the wings (pull towards you).

-pulls the bumper forward.

-remove the connector from the fog lamp (if any).

Rear bumper

-open the trunk lid.

-(sedan) opening the trunk, Unscrew the four screws that secure the tail lights.

-exempt in the trunk side trim.

-for casings, Unscrew the nuts and remove the tail lights.

-under the rear lights under the tail lights, Unscrew the screws and release the latches.

-Unscrew the screws (take out the rivets) in the opening of the trunk.

-Unscrew the screws and take out the caps at the bottom (twisted and inserted from the bottom up).

-Unscrew the screws in the wheel arches and removed the fender liner.

-for wheel arch liners Unscrew one screw on each side that attach the angles to the wings (if any).

-with the assistant release the latch in the wings (pull the corners themselves).

-remove the bumper from the guides ago.

-remove the connectors from the equipment (if any).