Front bumper

-open the hood.

-under the hood take out the caps and Unscrew the screws that secure the top.

-Unscrew the screws and remove the headlamp.

-in the openings of the headlight Unscrew the screws and take out the caps.

-wrenched the wheel to the left or right side depending on which side we will analyze first.

-wheel arches Unscrew the screws that attach the fender liner.

-Unscrew one screw on each side (spun up). Holding the angles to the wings.

-on the perimeter in the lower part and pull out the caps.

-pulls the bumper forward (making sure not to break the wires).

-remove the connector from the equipment (if any).

front bumper mounting scheme Chevrolet Epica (2003-2006)

front bumper mounting scheme Chevrolet Epica (2003-2006)

front bumper mounting scheme Chevrolet Epica (2003-2006)

Rear bumper

⇒Tips for removing bumpers and how to avoid breaking anything..⇐

-open the trunk lid.

-remove side trim.

-for casings Unscrew two screws on each side (twisted from top to bottom) that attach the sides to the wings.

-Unscrew the nuts and remove the tail lights.

-take out the caps in the opening of the trunk and under the taillights.

-Unscrew the screws around the perimeter of the bottom.

-Unscrew the screws in the wheel arches and removed the fender liner.

- Unscrew one screw on each side (spun upwards) holding the corners to the wings.

-remove the bumper from the guides ago.

-remove the connectors from the equipment (if any).

tail lights mounting scheme Chevrolet Epica (2003-2006)

rear bumper mounting scheme Chevrolet Epica (2003-2006)

rear bumper mounting scheme Chevrolet Epica (2003-2006)

rear bumper mounting scheme Chevrolet Epica (2003-2006)

 

How to remove front and rear bumper Chevrolet Epica (after 2006)