Chevrolet Epica II (2006-2012) how to remove bumpers.

Chevrolet Epica V250 (2006-2012)

Depending on the year of manufacture, the mounting points may vary slightly.

How to Remove the Front Bumper

Open the hood.
Under the hood, unscrew the four screws (fastened from top to bottom) that secure the upper part of the front bumper (radiator grille).
From underneath the car, unscrew the screws (fastened from bottom to top) that secure the lower part.
Unscrew three screws on each side and pull out the headlights.
Under the headlights, unscrew four screws.
Turn the wheels to the side.
In the wheel arches, release the front part of the fender liners.
Move the fender liners aside and unscrew two screws on each side that secure the sides to the fenders.
With the help of an assistant, pull the bumper forward (be careful not to tear any wires).
Disconnect the electrical connectors (if any).

How to Remove the Rear Bumper

Open the trunk lid.
In the trunk opening, unscrew four screws and remove the rear lights.
Under the rear lights, unscrew one screw on each side that secures the upper part of the rear bumper.
From underneath the car, unscrew six screws (fastened from bottom to top) that secure the lower part.
In the wheel arches, unscrew the screws that secure the rear part of the fender liners.
Behind the fender liners, unscrew one screw on each side (fastened from bottom to top) that secures the corners to the fenders.
Release the clips in the fenders (pull the corners down and toward yourself).
Release the fasteners in the trunk opening.
With the help of an assistant, remove the bumper backward (be careful not to tear any wires).
Disconnect the electrical connectors (if any).