Chevrolet Corvette C7 (2014-2019) Z06, ZR1
Depending on the year of manufacture, the mounting locations may vary slightly.
How to remove the front bumper
-open the hood.
-near the wings, remove two plastic covers (pull up).
-unscrew the two screws and take out the two pistons that secure the upper part of the front bumper.
-from the bottom side, unscrew ten 7mm screws and four 10mm screws, remove the protection.
-under the sewing, unscrew the four screws (twisted from bottom to top) that secure the lower part.
-turn the wheels left or right depending on which side we will disassemble first.
-in the wheel arches, unscrew three screws on each side that secure the fender liners (front part).
-behind the wheel arch liners we release the electrical connectors.
-release the latches in the wings (pull towards yourself).
-release the fasteners under the hood (pull up).
-with an assistant, pull the bumper forward (pay attention to the upper part so as not to damage the bumper on the hood).
How to remove the rear bumper
-open the trunk lid.
-remove the sealing strip (held on by latches, pull it towards the trunk and up).
-under the trim, Unscrew the ten screws (twisted from top to bottom) that secure the upper part of the rear bumper.
-from the bottom, unscrew ten screws (twisted from bottom to top) that secure the lower part.
-unscrew the two screws in the exhaust pipe opening.
-remove the decorative trims around the rear lights (they are held on by latches, you need to pry them and pull them towards you).
-under the decorative trims, Unscrew the two screws.
-in the wheel arches and release the linings (held on by latches).
-under the trims, unscrew three screws on each side and release the fender liners (rear part).
-behind the wheel arch liners we release the electrical connectors.
-release the latches in the wings (pull towards yourself).
-with an assistant, remove the bumper backwards (make sure not to break the wires).
-remove the connectors from the electrical equipment.