Chevrolet Cruze I (2008-2016) how to remove bumpers.
Chevrolet Cruze J300 (2008-2016) (sedan, hatchback, wagon)
Depending on the year of manufacture, the mounting locations may vary slightly.
How to remove the front bumper
-open the hood.
-under the hood, unscrew the two screws and take out the four pistons (twisted and inserted from top to bottom) that secure the upper part of the front bumper.
-from the bottom side, unscrew the four screws that secure the fender liners and take out the four pistons that secure the engine compartment protection (the bumper can be removed without engine compartment protection, then instead of the pistons you need to unscrew six screws).
-turn the wheels left or right depending on which side we will disassemble first.
-in the wheel arches, unscrew three screws on each side that secure the fender liners (front part).
-release the latches in the wings (pull the corners toward you).
-with an assistant, pull the bumper forward (watch the wires).
-disconnect the connectors of the electrical equipment (if any).
How to remove the rear bumper
-open the trunk lid.
-in the trunk, release the side trims and disconnect the rear light connectors behind them.
-in the trunk opening, take out the four plugs and unscrew the screws under them that secure the rear lights.
-remove the rear lights (they are held on by clips in the wings).
-from the bottom we take out two pistons (in the station wagon we unscrew two more screws).
-in the wheel arches, unscrew two screws on each side that secure the fender liners and one screw (twisted from bottom to top) that secure the corners to the wings.
-release the latches in the wings (pull the corners down and towards you).
-release the latches under the rear lights.
-with an assistant, remove the bumper backwards (make sure not to break the wires).
-remove the connectors from the electrical equipment.
English 
Italiano 
Français 
русский 
Deutsch 
Español 
