Chevrolet Aveo / Sonic (2012-2020) how to remove bumpers.
Chevrolet Aveo II T300 (Sonic) (2012-2020)
Depending on the year of manufacture, the mounting locations may vary slightly.
How to remove the front bumper
-open the hood.
-under the hood, unscrew the four screws and take out the six pistons (twisted and inserted from top to bottom) that secure the upper part of the front bumper (lining).
-from the bottom, unscrew the five screws and remove the protection.
-unscrew the six screws (twisted from bottom to top) that secure the lower part.
-in the wheel arches, unscrew three screws on each side that secure the fender liners (front part).
-unscrew one screw on each side (twisted from bottom to top) that secure the corners to the wings.
-release the latches in the wings (pull the corners toward you).
-release the latches under the headlights.
-with an assistant, pull the bumper forward (watch the wires).
-remove the connectors from the fog lights (if any).
-from the bottom we take out the four pistons and unscrew the two screws (twisted and inserted from the bottom up) that secure the lower part of the rear bumper.
-in the wheel arches, unscrew the screws that secure the fender liners (rear part) and mud flaps.
-(sedan) unscrew one screw on each side (twisted from bottom to top) that secure the corners to the wings.
-release the latches in the wings (pull the corners toward you).
-release the latches under the rear lights.
-release the latches in the trunk opening.
-with an assistant, carefully pull the bumper back (make sure not to break the wires).
-disconnect the connectors of the electrical equipment (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español 
