-
-
-
Front bumper
-Unscrew the wheel to the left or right side, depending on which side will spin first.
-wheel arches Unscrew the screws that attach the fender liner to the bumper.
-for wheel arch liners Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the body.
-under the hood, Unscrew the two screws (spun down).
-with a screwdriver freed the upper part of the grille from the clips and attach themselves.
-remove the grille upwards.
-throughout the length of the lower part of the bumper, Unscrew the screws (spun upwards).
-we release the bumper from the clips under the grille and under the wings and pulls forward.
-remove the connectors from the fog lights.
- if you have headlight washers, disconnect the hose and plug the cap to the reservoir was leaking fluid.
-remove connector from the PDC (if any).
Rear bumper
-in the boot remove the side trim (you need to access the rear part of the rear lights in the wings).
-under the panels, Unscrew the screws and remove the tail lights.
-Unscrew the screws and take out the caps at the bottom (spun up).
-Unscrew the screws in the wheel arches that secure the wheel arches (not to remove the wheel, remove ratchet with a nozzle).
-for wheel arch liners Unscrew one screw on each side (twisted in the wings upward).
-we release the latch in the wings, behind the rear lights and opening boot.
-With an assistant, pull the bumper back from the side rails.
-remove the connectors from the light plate.
-remove connector from the PDC (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español