-Unscrew the wheel to the left or right side, depending on which side of the bed will be dismantled.
-wheel arches Unscrew the screws that attach the fender liner to the bumper.
-Unscrew the screws that attach the bumper to the wings (spun upwards).
under the hood, Unscrew the screws and pull out the clips that secure the grille.
-Unscrew the two screws at the bottom and remove the grille.
-Unscrew the two screws under the grille.
-pulls the bumper forward in the direction of movement of the guide (need to do this with a helper so as not to scratch the paint on the wings).
-you can now unplug the connectors from the fog lights (if any).
-remove connector from the PDC (if any).
- if there is paramilitary disconnect the hoses from the injectors and close them with stoppers that from the reservoir was leaking fluid.
Rear bumper
-you need to access the inner part of the rear lights. In the boot remove the side trim, Unscrew mounting nuts and remove the tail lights.
-Unscrew two screws each side under the rear lights.
-wheel arches Unscrew the screws that attach the bumper to the fender liner (not to remove the wheels, you can use a ratchet with a nozzle) and one on each side to the wings.
-Unscrew the screws (spun upwards) around the perimeter at the bottom of the bumper.
-pulls back from the rails (this should be done with an assistant, so as not to scratch the paint on the wings).
English 
Italiano 
Français 
русский 
Deutsch 
Español 
