How to remove front and rear bumper VW PASSAT B7 (CC)
Front bumper
-Unscrew the wheel to the left or right side, depending on which side of the bed will be dismantled.
-wheel arches Unscrew the screws that attach the fender liner to the bumper.
-move the wing flaps to the side and Unscrew the screws that attach the bumper to the wings (spun upwards).
-open the hood and Unscrew the screws that secure the grille.
-in the lower part, along the entire length Unscrew the seven screws which secure the protection of the engine and wing flaps.
-rip off the bumper with clips (the edges pull away from the car) and pulls in the front (need to do this with a helper so as not to scratch the paint on the wings).
-you can now unplug the connectors from the fog lights (if any).
-remove connector from the PDC (if any).
- if there is paramilitary disconnect the hoses from the injectors and close them with stoppers that from the reservoir was leaking fluid.
Rear bumper
-wheel arches Unscrew the screws that attach the fender liner to the bumper (so as not to remove the wheels, you can use a ratchet with a nozzle).
-for the wheel arches, in the corners of the bumper, take out one plastic clip on each side.
-now you need to access the inner part of the rear lights. In the boot remove the side trim, Unscrew mounting nuts and remove the tail lights.
-under the rear lights Unscrew two screws on each side (spun down).
-Unscrew the screws (spun upwards) and pull out the caps on the perimeter in the lower part of the bumper.
-break away from the latches (the edges pull apart) and pulls the bumper back (this should be done with the assistant, so as not to scratch the paint on the wings).
English 
Italiano 
Français 
русский 
Deutsch 
Español 
