Front bumper

-Unscrew the wheel to the left or right side, depending on which side of the bed will be dismantled.

-wheel arches Unscrew the screws that attach the fender liner to the bumper.

-for wheel arch liners Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the body.

-open the hood and remove the grille. In the upper part Unscrew the four screws (spun down), the lower part of the pull itself (fixed by the latches).

-under the grille, Unscrew the screws, one near the headlights.

-throughout the length of the lower part of the bumper, Unscrew the screws (spun upwards).

-pull the corners and pulls the bumper from the guides themselves.

-remove the connectors from the fog lights.

- if you have headlight washers disconnect the hose and plug the cap to the reservoir was leaking fluid.

the attachment of the front bumper VW Golf 6

Rear bumper

-wheel arches Unscrew the screws that attach the fender liner to the bumper and the bumper to the wing (to remove the wheels, use a ratchet with a nozzle).

-from under the car, in the lower part of the bumper, Unscrew the four screws (spun upwards).

-pulls in the side Luggage compartment trim (need to access the tail lights).

-Unscrew two nuts on each side and remove the tail lights.

-under the rear lights, Unscrew the screws (spun down).

-pulls edges to the sides, tearing off the latches (this should be done together) and pulls the bumper back.

- remove the connector from the license plate light.

-remove connector from the PDC (if any).

-the bumper is cleared.

the attachment of the rear bumper VW Golf 6

diagram of rear bumper VW Golf 6